Поделиться можно.
Но изучать на своем аппарате надо осторожно.
Сначала запомни или запиши какие настройки были до твоего вмешательства (чтоб восстановить можно было при случае).
No. Test Component     Detection status
01 Paper detection sensor     Reflected light is detected
02 Elevator upper limit sensor     Light path is blocked
03 Elevator lower limit sensor     Light path is blocked
06 Paper sensor     Light path is blocked
08 Position-A sensor     Light path is blocked
09 Clamp sensor A     Light path is blocked
10 Clamp sensor B     Light path is blocked
12 Cutter position switch     Actuator is not pressed
14 Master sensor     Reflected light is detected
15 Master positioning sensor     Reflected light is detected
17 Ink pack set sensor     Light path is blocked
18 Drum set sensor     Light path is blocked
19 Paper receiving sensor     Reflected light is detected
21 ADF set sensor     Light path is blocked
22 Vertical centering sensor     Light path is blocked
23 Master end sensor     Light path is blocked
24 Master tension plate sensor     Light path is blocked
25 Master compressing sensor     Light path is blocked
26 Master full detection sensor Light path is blocked
27 Master removal unit set SW     Actuator is pressed
28 Master removal sensor     Actuator is pressed
29 Master making unit set SW     Actuator is pressed
34 Original detection sensor     Actuator is pressed
36 Original IN sensor     Reflected light is detected
37 Ink sensor         Ink is detected
38 Overflow sensor     Ink is detected
41 Option board detection signal When Option board attached
56 Original feed solenoid
57 Write pulse motor (reverse) 200 dpi speed
58 Write pulse motor (forward) 200 dpi speed
59 Main motor (10 rpm) All the Safety switches must be pressed and the Drum must be set in the machine.
60 Main motor (15 rpm)All the Safety switches must be pressed and the Drum must be set in the machine.
61 Main motor (30 rpm)All the Safety switches must be pressed and the Drum must be set in the machine.
62 Main motor (Variable Speed) Speed changeable by Print speed key on the panel. All the Safety switches must be pressed and the Drum must be set in the machine.
63 Separation Fan + Suction Fan
64 Write pulse motor (forward) 400 dpi speed
65 Write pulse motor (forward) 300 dpi speed
66 Master loading clutch
67 Paper feed clutch
68 Pressure solenoid
69
70 Clamp home positioning movement
71 Master removal motor
73 Clamp motor
74 Read pulse motor (forward direction) Speed changeable by Reproduction Ratio key on the panel
77 TPH control signal
79 Image scanner LED
84 Read pulse motor (reverse direction)
89 Master tension plate solenoid
Не спеши менять что то если аппарат работает исправно. ибо это не механика а электроника - дело тёмное.

Велик и могуч русский язык, английский тоже красивый язык, но лучше сперва выучить русский, может тогда кто-то чем-то и поможет